English
 |
| Quantity: | |
|---|---|
Position: Cold Flying Shear is located at the outlet roller table of the cold bed.
Structure: Double motor parallel drive gantry crank flying shear
Purpose: Cold Flying Shear is used to cut the outlet rolled parts from the cold bed to the length of finished products.
Technical parameters:
Rolling speed: ≤1.5m/s
Rolling section: ≤φ40mm
Width of cutting edge: ≤950mm
Maximum shear force: 450t
Position: Cold Flying Shear is located at the outlet roller table of the cold bed.
Structure: Double motor parallel drive gantry crank flying shear
Purpose: Cold Flying Shear is used to cut the outlet rolled parts from the cold bed to the length of finished products.
Technical parameters:
Rolling speed: ≤1.5m/s
Rolling section: ≤φ40mm
Width of cutting edge: ≤950mm
Maximum shear force: 450t
